| Option | Description | Details |
|---|
| (Option 4) | 140 MHz IF Freq | |
| (Option 10C) | Higher Frequency Stability | |
| Option 14 | Front panel selectable 50/75 ohms IF impedance | |
| (Option 10G) | Higher Frequency Stability | Phase Tracking Reference |
| (Option 15) | 50 Ohm IF Impedance | |
| (Option 10H) | Higher Frequency Stability Reference | Phase Tracking Reference |
| (Option 17C) | RS232 | |
| (Option 18) | 15 VDC/10 MHz for BDC | |
| (Option 19B) | L-band Fiber Optic Interface (FIber Optic Input) | |
| (Option 20) | Selectable 70 MHz and 140 MHz frequencies. | One IF connector provided at rear panel (BNC female).
Selection of IF frequency is available from the front panel and over the remote bus. |
| (Option 32) | Amplitude Slope adjust ±2 dB in 0.2 dB steps | |
| NRF | Type N female RF Connector and IF monitor (Note: Monitor remains SMA female) | |
| TNCRF | Type TN female RF Connector (Note: Monitor remains SMA female) | |
| TNCIF | Type TNC Female IF Connector and IF monitor | |
| TNCREF | Type TNC Female REF Connector | |
| SLIDE EXT | SLIDE EXTENSION 6" | SLIDE EXTENSION 6" |
| (Option 31) | Ultra low phase noise (see data sheet for Phase Noise specifications chart). | Option 10E (analog reference phase lock) supplied as standard and internal reference U-link provided (an external 10 MHz reference may be applied). Higher frequency stability available for details. See options 10 and 10F.
|
Please review the product PDF which contains the full and complete specifications.
For conflicts between the information on this page and the product PDF, the product PDF takes precedence.
